The common problems and solutions in the operation of semi-automatic screen printing machine
date：2017-04-06
source：本站
Due to the moderate price and perfect function of the semi-automatic screen printing machine, it has also become the best choice for many small and medium-sized printing enterprises to choose screen printing equipment. However, whether it is because of the wear of the parts of the semi-automatic screen printing machine, the error of the operation of the equipment or some external factors, it may lead to a variety of problems in the normal operation of the semi-automatic screen printing machine. As the largest silk screen printing machine production base in the Central Plains, Zhengzhou Sikerui shoulders the burden of the leading screen printing machine industry in the central region, and it is necessary to solve the common problems of semi-automatic screen printing machines for everyone.
1, the operation standard, but the equipment can not automatically run. To ensure that the equipment operator to determine the operation of the premise. This kind of failure generally occurs in machines with a running time of about 3 years, due to the long-term overload operation, coupled with the maintenance of many users of the equipment does not meet the standard requirements, there is a phenomenon that such switches are open but the equipment is unable to operate automatically. The solution to this problem is to check whether the timer and the microswitch are faulty, and then choose to replace the timer or repair the microswitch for the faulty part.
2, the semi-automatic foot switch of the semi-automatic screen printing machine fails, which is shown as the slide seat drops after stepping on the foot switch, and rises after letting go. The main reason for this kind of failure is that the switch on the left side of the transverse slide cannot work normally, and the common situation is that the overload operation of the foot switch leads to this kind of situation, and the specific solution is to replace the new switch.
3, semi-automatic screen printing machine in normal operation when the table surface can not absorb gas. The probability of such problems is relatively small, and the main reason is that the suction motor is burned out or the solenoid valve is damaged. No matter the probability of the former occurring is relatively large, there is generally no
In the case of suction, just change the suction motor.
4, when the semi-automatic screen printing machine is running, when stepping on the semi-automatic foot switch, the slide seat falls left and rises but does not move to the right. Most of the reasons for the screen printing machine wiring switch is damaged or there is no induction. Usually replace the switch can be done.
5. After the semi-automatic screen printing machine stops running, the power light is still on. This phenomenon is mainly a blown fuse. Just replace the fuse.
6. The scraper does not fall after the semi-automatic screen printing machine is opened. This is still the switch fault, replace the selection switch can be.
7. The semi-automatic screen printing machine starts to work before stepping on the foot switch. This is mostly a foot switch multi-way, shut down and cut off the power after the switch can be replaced.
8, After switching the working state between semi-automatic and manual operation, the rising action of the working tile knife is very slow. Check whether the solenoid valve is blocked by foreign matter and clean the solenoid valve or replace it with a new one.
